How many people are poisoned from CO each year?
Nearly 5,000 people in the United States are treated in hospital emergency rooms for CO poisoning; this number is believed to be an underestimate because many people with CO symptoms mistake the symptoms for the flu or are misdiagnosed and never get treated.
Dangerous levels of CO can be prevented by proper appliance maintenance, installation, and use:
• A qualified service technician should check your home's central and room heating appliances (including water heaters and gas dryers) annually. The technician should look at the electrical and mechanical components of appliances, such as thermostat controls and automatic safety devices.
• Chimneys and flues should be checked for blockages, corrosion, and loose connections.
• Individual appliances should be serviced regularly. Kerosene and gas space heaters (vented and unvented) should be cleaned and inspected to insure proper operation.
• CPSC recommends finding a reputable service company in the phone book or asking your utility company to suggest a qualified service technician.
• Proper installation is critical to the safe operation of combustion appliances. All new appliances have installation instructions that should be followed exactly. Local building codes should be followed as well.
• Vented appliances should be vented properly, according to manufacturer's instructions.
• Adequate combustion air should be provided to assure complete combustion.
• All combustion appliances should be installed by professionals.
Follow manufacturer's directions for safe operation.
• Make sure the room where an unvented gas or kerosene space heater is used is well ventilated; doors leading to another room should be open to insure proper ventilation.
• Never use an unvented combustion heater overnight or in a room where you are sleeping.
Are there signs that might indicate improper appliance operation?
Yes, these are:
• Decreasing hot water supply
• Furnace unable to heat house or runs constantly
• Scooting, especially on appliances
• Unfamiliar or burning odor
• Increased condensation inside windows
Are there visible signs that might indicate a CO problem?
Yes, these are:
• Improper connections on vents and chimneys
• Visible rust or stains on vents and chimneys
• An appliance that makes unusual sounds or emits an unusual smell
• An appliance that keeps shutting off (Many new appliances have safety components attached that prevent operation if an unsafe condition exists. If an appliance stops operating, it may be because a safety device is preventing a dangerous condition. Therefore, don't try to operate an appliance that keeps shutting off; call a service person instead.)
Are there other ways to prevent CO poisoning?
Yes, these are:
• Never use a range or oven to heat the living areas of the home
• Never use a charcoal grill or hibachi in the home
• Never keep a car running in an attached garage
CO can be detected with CO detectors that meet the requirements of Underwriters Laboratories (UL) standard 2034.
Since the toxic effect of CO is dependent upon both CO concentration and length of exposure, long-term exposure to a low concentration can produce effects similar to short term exposure to a high concentration.
Detectors should measure both high CO concentrations over short periods of time and low CO concentrations over long periods of time - the effects of CO can be cumulative over time. The detectors also sound an alarm before the level of CO in a person's blood would become crippling. CO detectors that meet the UL 2034 standard currently cost between $35 and $80.
Where the detector should be installed?
CO gases distribute evenly and fairly quickly throughout the house; therefore, a CO detector should be installed on the wall or ceiling in sleeping area/s but outside individual bedrooms to alert occupants who are sleeping.
Aren't there safety devices already on some appliances? And if so, why is a CO detector needed?
Vent safety shutoff systems have been required on furnaces and vented heaters since the late 1980s. They protect against blocked or disconnected vents or chimneys. Oxygen depletion sensors (ODS) have also been installed on unvented gas space heaters since the 1980s. ODS protect against the production of CO caused by insufficient oxygen for proper combustion. These devices (ODSs and vent safety shutoff systems) are not a substitute for regular professional servicing, and many older, potentially CO-producing appliances may not have such devices. Therefore, a CO detector is still important in any home as another line of defense.
Are there other CO detectors that are less expensive?
There are inexpensive cardboard or plastic detectors that change color and do not sound an alarm and have a limited useful life. They require the occupant to look at the device to determine if CO is present. CO concentrations can build up rapidly while occupants are asleep, and these devices would not sound an alarm to wake them.
For additional information, write to the U.S. Consumer Product Safety Commission, Washington, D.C., 20207, call the toll-free hotline at 1-800-638-2772, or visit the website http://www.cpsc.gov